Burris MTAC™ — Riflescopes
Status — Discontinued: All Burris MTAC models (including 1–4×24, 1.5–6×42, 3.5–10×, 4.5–14×, 6.5–20×) are discontinued. This article is retained for support and service reference.
Models covered (family): 1–4×24 · 1.5–6×42 · 3.5–10× · 4.5–14× · 6.5–20×
Tech Note — Click Units: MTAC uses two systems by model: 1–4×24 & 1.5–6×42 have 0.5 MOA clicks; higher-power models (3.5–10×, 4.5–14×, 6.5–20×) use 0.1 mrad (1 click = 0.1 mrad, 5 mils per revolution).
1) Itemized Components (Product Map)
| Item # | Component | Function |
|---|---|---|
| 1 | Eyepiece / Diopter | Focus the reticle sharp/black to your eye (quick-glance method). |
| 2 | Power (Zoom) Ring | Set magnification. |
| 3 | Elevation Turret | Impact UP/DOWN; resettable dial after zero. |
| 4 | Windage Turret | Impact LEFT/RIGHT; resettable dial after zero. |
| 5 | Illumination Knob | Rotary switch with 10 levels and OFF detents; CR2032 battery. |
| 6 | Parallax / Focus Ring* | On select models; adjustable ring on the objective bell. |
| 7 | Objective Bell / Lens | Primary light-gathering lens. |
* Parallax/focus adjustment present on models so equipped.
2) Using the Scope (Focus, Parallax)
- Eyepiece focus: Point at the sky/plain wall and take quick glances while rotating the eyepiece until the reticle appears crisp and black. Don’t stare while turning (prevents your eye from “auto-focusing”).
- Parallax/focus (models with AO): Rotate the ring on the objective bell until the image is sharp and the reticle no longer appears to move against the target when you shift your eye position.
3) Turrets — Click Values & Reset-to-Zero
| Model Group | Click Value | Per-Rev Travel | Reset-to-Zero Steps |
|---|---|---|---|
| 1–4×24 & 1.5–6×42 (low-profile) | 0.5 MOA per click | — | Remove caps → hold knob to prevent turning → insert a pen in the small hole opposite “0” → rotate numbered ring to “0” → release. |
| 3.5–10×, 4.5–14×, 6.5–20× (mil target knobs) | 0.1 mrad per click | 5 mils per revolution | Remove caps → loosen top set-screws with the hex wrench → rotate dial to “0” (don’t lift) → retighten. |
Resetting to “0” is optional but helpful for quick confirmation of zero.
4) Illumination (All Illuminated Models)
- Control: Rotary dial on the left side of the turret housing with 10 brightness levels and OFF detents between levels.
- Battery: CR2032, install flat side “+” up in the illumination knob. Remove the battery for long-term storage.
5) Reticles — Overview
| Reticle | Where / Use | Notes |
|---|---|---|
| Ballistic CQ™ | 1–4×24 & 1.5–6×42 | Fast circular center for close targets; lower dots give holds to ~600 yd for common 5.56/7.62 loads; hash marks subtend ~18″ at labeled distances for quick size estimation. |
| Ballistic 5X™ | 1–4×24 (select SKUs) | CQB ring with extended drop stadia for 5.56/7.62; illuminated. |
| G2B Mil-Dot™ | Mid/high-power models | Mil-based with half-mil hashes between dots for precise ranging, holdover, and windage; calibrated at high power. |
| Ballistic Milling Reticle | Select high-power models | 0.5- and 1-mil hashes; lower vertical tree to ~700 yd (optimized around 500 yd for flat-shooting varmint loads). |
6) Care & Maintenance
- Fully waterproof and fogproof. For heavy dirt (e.g., dried mud), rinse with clean water or lens fluid first, then use a soft brush or Lens Pen to finish.
- All moving assemblies are factory-lubed; do not disassemble. Contact Burris support if service is needed.
7) Quick Reference (by model)
| Model | Clicks | Parallax / Focus | Reticle Options |
|---|---|---|---|
| 1–4×24 | 0.5 MOA | Fixed @ 100 yd | Ballistic CQ™ / Ballistic 5X™ (illuminated) |
| 1.5–6×42 | 0.5 MOA | Fixed or AO (see model) | Ballistic CQ™ |
| 3.5–10× | 0.1 mrad (5 mils/rev) | AO on objective bell | G2B Mil-Dot™ / BMR |
| 4.5–14× | 0.1 mrad (5 mils/rev) | AO on objective bell | G2B Mil-Dot™ / BMR |
| 6.5–20× | 0.1 mrad (5 mils/rev) | AO on objective bell | G2B Mil-Dot™ / BMR |
8) 1–4×24 — Item Numbers
| Item # | Description |
|---|---|
| 200426 | Scope only — Ballistic 5X™, matte black |
| 200437 | Scope only — Ballistic CQ™, matte black |
| 200457 | Scope only — Ballistic 5X™, Prym 1 “Blackout” camo |
| 200466 | Scope only — Ballistic 5X™, Prym 1 “Sandstorm” camo |
| 200426-FF | Tactical kit — Ballistic 5X™, + FastFire 3 + P.E.P.R. mount |
| 200437-FF | Tactical kit — Ballistic CQ™, + FastFire 3 + P.E.P.R. mount |
| 200465 | Tactical kit — Ballistic 5X™, Prym 1 “Blackout” camo |
| 200467 | Tactical kit — Ballistic 5X™, Prym 1 “Sandstorm” camo |
9) Warranty
Covered by the Burris Signature Warranty™.
User Guide (PDF): MTAC™ Riflescopes — User Guide
Comments
0 comments
Please sign in to leave a comment.