How To Use BurrisConnect With The Eliminator 6.

How to Connect the Eliminator® 6 to the Burris Connect App

This guide walks you through connecting your Eliminator 6 to the Burris Connect app, uploading ballistic profiles, and adjusting HUD and system settings.

STOP — Before You Continue

Make sure you have allowed Bluetooth access for the BurrisConnect app in your phone’s system settings.

If Bluetooth permissions are disabled, your scope will not connect — even if Bluetooth is turned on.

Video Tutorial

Watch the full setup and configuration tutorial below:

What You Need

• Your Eliminator 6 riflescope
• One CR123A battery
• A smartphone (Apple or Android)
• The Burris Connect app (free in the App Store or Google Play)
• Your Eliminator 6 User Manual

Step 1: Download the Burris Connect App

1. Open the App Store (iPhone) or Google Play Store (Android).
2. Search for “Burris Connect.”
3. Download and install the app.

Step 2: Install the Battery in the Eliminator 6

1. Remove the battery cap on the left side of the scope.
2. Insert the CR123A battery in the correct orientation.
3. Align the pins and reinstall the battery cap until secure.

Step 3: Power On and Connect to the App

1. Press the front rangefinder button to power on the scope.
2. Look through the optic — if the battery icon appears, the unit is on.
3. Open the Burris Connect app:
   • Tap on the Optics tab
   • Tap the + symbol
   • Select Eliminator 6
4. Follow the on-screen instructions. The app will prompt you to press the front button again.
5. When your scope appears (identified by serial number), tap it to connect.

Step 4: Customize Your Heads-Up Display (HUD)

After pairing, you can configure the Eliminator 6 HUD to your preferences.

Key Adjustable Options:

• Range units: yards or meters
• Temperature: °F or °C
• Energy: ft-lbs or joules
• Velocity: ft/sec or m/sec
• Wind units: mph, kph, or m/sec
• Shot Call Marker: enable/disable or set energy/velocity threshold

Step 5: Control What You See on the HUD

Your HUD contains 11 display zones, each of which can be turned on or off.

Two Display Stages

• Initial Timeout — what appears immediately after ranging
• Extended Timeout — what appears after 15, 30, or 60 seconds

To Edit The Display Settings:

1. Select the zone you want to configure.
2. If the icon is bright red, the zone is active.
3. To adjust the display timeout values:
   • Press on Initial Timeout: 5–30 seconds
   • Press on Extended Timeout: 15–60 seconds

Step 6: Adjust the Level Indicator

• Choose from three level indicator display styles.
• Select bubble or ball graphic.
• Set sensitivity to 0.5° or 1°.

Note: All changes sync instantly to the scope. No “Save” button needed.

More Resources

Watch the full Eliminator 6 video series:

For additional support and product information, visit burrisoptics.com .